Here's a great video from Thomas on how to add an additional receiver to your Guardline Driveway Alarm. (This works for the 1/4 mile and the 500 ft versions)

For a transcription of this video, see below:

 

How’s it going today? It’s Thomas with Guardline Security, and today we’re going to be going over adding an additional receiver to your existing Guardline Driveway Alarm.

When adding an extra receiver to an existing Guardline setup, you will follow the same steps that you did when pairing your set initially.

Press and hold the LEARN button on the side of your extra receiver for three seconds or until your Zone One LED starts to blink.

Now, in most cases when adding an extra receiver, you’ll want to choose the same zone and melody that you did with the first receiver. If you wish to change the melody, you can do that at this point by pressing the MELODY button to cycle through them.

Now, since we’re using Zone One and the default melody on this receiver, the only step left is to activate or sensor, receive the audio cue that it has been paired with the extra receiver, and press the LEARN button to cycle through these zones until none of the lights are blinking and you are out of LEARN mode.

At this point, if I activate my sensor, I should receive a notification on both of these receivers, in Zone One, with the default melody. Adding an extra receiver to your existing Guardline setup is that simple.

As always, thanks for watching, and if you have any additional questions or comments, feel free to reach out and contact us at Guardlinesecurity.com.



Search

Just added to your cart:
Qty:
Total:
Subtotal:
 
Just added to your wishlist:
Excl. postage 
My Wishlist