Pairing Additional Sensors or Devices to a Guardline Driveway Alarm
Here's Thomas showing us how to add an additional sensor to the Guardline wireless driveway alarm.
To read the transcript this video on how to pair sensors to Guardline's wireless driveway alarms, see below:
How’s it going today? It’s Thomas with Guardline Security, and today we’re going to be going over adding an additional device to your existing Guardline Driveway Alarm.
In this scenario, we already have a motion sensor paired to Zone One on our receiver, with the default melody. To pair another device to Zone Two, the steps will be similar.
The first thing you want to do is put your receiver into LEARN mode by holding the LEARN button on the side until your Zone One LED starts to blink. At this point, you can press the LEARN button one more time to move your LEARN indicator to Zone Two.
With your LEARN indicator in Zone Two, you’re ready to select a melody for your second device. Do this by locating the MELODY button on the side of your receiver and pressing that to cycle through the available melodies.
That melody is paired to our motion sensor in Zone One, so to make this less confusing, we’re going to choose a different melody.
With your melody selected and your LEARN indicator in Zone Two, all that is left is to activate your Guardline doorbell, receive the audio confirmation that it’s been paired, and then press the LEARN button a few times to cycle through these zones until no lights are blinking.
Now if I activate my motion sensor, I should get a notification on Zone One with the default melody. And if I activate my push button, I should receive a notification on Zone Two with the selected melody.
As always, thanks for watching, and if you have any additional questions or comments, feel free to reach out and contact us at Guardlinesecurity.com.
